Grass Valley 3-CCD CameraMan - Manual (Page 48)

48 CameraMan Installation and Operation Manual
Appendix H — CPT 2018-A3D On-Screen Menus
G/L Color Bar Setting
Figure 27. G/L Color Bar Setting Submenu
Sharpness (DTL) Setting
Figure 28. Sharpness (DTL) Setting Submenu
Table 3. G/L Color Bar Settings
H Phase (-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.
SC Coarse (1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is sup-
plied.
SC Fine (-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is sup-
plied.
Color Bar Set (0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
Table 4. Sharpness (DTL) Settings
DTL Select (Sharpness, Super DTL) If contour correction is not sufficient at the Sharpness position when
Detail Level setting is set to LOW or HIGH, select the Super DTL position.
*Neither Sharpness nor Super DTL is valid for contour correction if Detail Level setting is in the
OFF position.
Level (OFF, Low, High) Detail level can be adjusted when DTL Select setting is at Sharpness. Super DTL
level can be adjusted when DTL Select setting is at Super DTL.
Noise Suppress (OFF, Low, High) Screen noise can be reduced when Level setting is at HIGH or LOW.
Clean DNR (OFF, Low, High) This enables the clean DNR effect to be selected.
3D-DNR (OFF, Low, Mid, High) This enables the 3D-DNR effect to be selected.
When “Mid” or “High” is selected, the noise is reduced but lag increases.
DTL Flesh Tone Low: The roughness of the flesh tones is minimized.
Mid: This is the standard setting.
High: The outline compensation for the flesh tones is accentuated.