beautypg.com

G/l, color bar setting, Figure 55. g/l, color bar setting submenu, Table 28. color bar settings – Grass Valley 3-CCD CameraMan User Manual

Page 82: Sharpness (dtl) setting overview, Figure 56. sharpness (dtl) setting submenu, Table 29. sharpness (dtl) settings

background image

82

CameraMan Installation and Operation Manual

Appendix J — CPT-2018-A3DS On-Screen Menus

G/L, Color Bar Setting

Figure 55. G/L, Color Bar Setting Submenu

Sharpness (DTL) Setting Overview

Figure 56. Sharpness (DTL) Setting Submenu

Table 28. Color Bar Settings

H Phase

(-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.

SC Coarse

(1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is supplied.

SC Fine

(-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is supplied.

Color Bar Set

(0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.

Color Bar Set2

(0.0 IRE, 7.5 IRE) Set 0.0 IRE for the SDI card.

Table 29. Sharpness (DTL) Settings

DTL Select

(Sharpness, Super DTL) If contour correction is not sufficient at the
Sharpness position when Detail Level setting is set to Low or High,
select the Super DTL position.
*Neither Sharpness nor Super DTL is valid for contour correction if
Detail Level setting is in the OFF position.

Level

(OFF, Low, High) Detail level can be adjusted when Detail Select
setting is at Sharpness. Super DTL level can be adjusted when it is
at Super DTL.

Noise Suppress

(OFF, Low, High) Screen noise can be reduced when Detail Level
setting is at High or Low.

Clean DNR

(OFF, Low, High) This enables the clean DNR effect to be selected.

Flesh Noise Sup.

(OFF, Low, High) Flesh noise is suppressed in two steps when the
Level setting is at High or Low.