Grass Valley 3-CCD CameraMan - Manual (Page 55)

CameraMan Installation and Operation Manual 55
User Mode Submenus Overview
Other Settings
Figure 35. Other Setting Submenus
Cy Phase Varies the hue of the cyan.
Cy_B Gain Increases or decreases the intermediate color between cyan and blue.
Cy_B Phase Varies the hue of the intermediate color between cyan and blue.
B Gain Increases or decreases the intermediate color between blue and magenta.
B Phase Varies the hue of the intermediate color between blue and magenta.
Table 11. Other Settings
Gamma (0.35 to 0.55) Gamma correction level can be set.
Knee Point 88% - 98%: The level of video signals subject to knee compensation (knee point) can be set.
Dynamic: Knee compensation level is automatically adjusted according to the scene.
White Clip (95% to 110%) The peak level of video signals to be white-clipped can be set.
Flare R/G/B (0 to 100) Flare correction level can be adjusted.
*Flare correction level has already been adjusted prior to shipment from the factory.
Black Stretch Black stretch to correct the suppression of black portions at low luminance can be set to ON or
OFF.
Clean DNR (High, Low, OFF) This enables the clean DNR effect to be selected.
3D-DNR (OFF, Low, Mid, High) This enables the 3D-DNR effect to be selected.
2D LPF (OFF, Low, High) The 2D lowpass filter that reduces moire and cross color can be set.
Field/Frame Field: CCD storage will be by field storage.
Frame 1: Vertical resolution increases in frame storage.
Frame 2: Vertical resolution is raised without increasing residual images by frame storage and
electronic shutter.
Baud Rate (1200bps, 2400bps, 4800bps, 9600bps) This setting is to select a communication speed in con-
trolling the camera from the computer.
Component This enables RGB, Y/Pr/Pb or Y/C to be selected as the component signals which are to be out-
put from the I/F REMOTE connector.
Digital Extender OFF: Under normal circumstances, this setting is used.
ON: An extender effect which is approximately 1.5 times greater is achieved. However, resolution
drops when the digital extender is set to “ON”.
Filter IR Through: The infrared shooting mode is established. Irradiate the subject with infrared light.
Normal: Under normal circumstances, this setting is used.
1/16ND: The 1/16 ND filter is inserted. Use this setting when the lens cannot be stopped down
enough by the diaphragm.
1/64ND: The 1/64 ND filter is inserted. Use this setting when the lens cannot be stopped down
enough by the diaphragm even at the 1/16ND setting.
Table 10. Color Matrix Settings