G/l adjustment settings, Figure 46. g.l adjustment setting submenu, Detail settings – Grass Valley 3-CCD CameraMan User Manual
Page 70: Figure 47. detail settings submenus, Table 21. detail settings

70
CameraMan Installation and Operation Manual
Appendix I — CPT 2018-A3DP On-Screen Menus
G/L Adjustment Settings
Figure 46. G.L Adjustment Setting Submenu
Detail Settings
Figure 47. Detail Settings Submenus
Table 1 —
H Phase
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.
SC Coarse
(1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is supplied.
SC Fine
(-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is supplied.
Table 21. Detail SEttings
Detail
(OFF, Low, High) Contour correction quantity can be selected. Detail settings made using the Hori-
zontal/Vertical Detail Level High/Low Setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the Detail setting at High or
Low.
Whichever the direction, H or V, the set level at High must be at least one position higher than that
at Low.
H Detail Level H
(L+1 to +63)
V Detail Level H
(L+1 to +31)
H Detail Level L
(0 to H-1)
V Detail Level L
(0 to H-1)
Detail Band
(1 to 5) A contour correction band can be set with the Detail setting at High or Low. The higher set-
ting, the finer will be the detail.
Noise Suppress
(1 to 10) Screen noise can be reduced with the Detail setting at High or Low. If the noise suppress
compensation level is set too high, a fine object will be reproduced less sharply.
Level Dependent
(0% to 25%) Screen noise due to the detail of dark parts of an object can be reduced. If level
dependent compensation level is set too high, however, hair, for example, will be reproduced less
sharply.