Grass Valley 3-CCD CameraMan - Manual (Page 53)

CameraMan Installation and Operation Manual 53
User Mode Submenus Overview
G/L Adjustment Settings
Figure 32. G/L Adjustment Setting Submenu
Detail Settings
Figure 33. Detail Setting Submenus
Table 8. G/L Adjustment Settings
H Phase (-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.
SC Coarse (1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is supplied.
SC Fine (-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is supplied.
Color Bar Set (0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
Table 9. Detail Settings
Detail (OFF, Low, High) Contour correction quantity can be selected. Detail settings made using the Hori-
zontal/Vertical Detail Level High/Low setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the Detail setting at High or
Low.
Whichever the direction, H or V, the set level at High must be at least one position higher than that at
Low.
H Detail Level H (L+1 to +63)
V Detail Level H (L+1 to +31)
H Detail Level L (0 to H-1)
V Detail Level L (0 to H-1)
Detail Band (1 to 5) A contour correction band can be set with the Detail at High or Low. The higher setting, the
finer will be the detail.
Noise Suppress (1 to 10) Screen noise can be reduced with the Detail setting at High or Low. If the noise suppress
compensation level is set too high, a fine object will be reproduced less sharply.
Level Dependent (0% to 25%) Screen noise due to the detail of dark parts of an object can be reduced. If level com-
pensation is set too high, however, hair, for example, will be reproduced less sharply.