Grass Valley 3-CCD CameraMan - Manual (Page 86)

86 CameraMan Installation and Operation Manual
Appendix J — CPT-2018-A3DS On-Screen Menus
Color Settings
Figure 59. Color Setting Submenu
G/L, Color Bar Settings
Figure 60. G/L, Color Bar Setting Submenu
Table 32. Color Settings
Chroma Level (-3 to +3) Chroma Level can be decreased or increased to three levels.
White Bal ATW: The white balance is automatically adjusted to the optimum position.
AWC A, AWC B: Once the white balance is adjusted with the ITEM/AWC switch on the
back of the camera, it is no longer necessary to set the white balance again if you
simply select AWC A or AWC B, provided that the camera is used under the same
conditions. Fine color adjustment can be made after setting AWC by red/blue gain
adjustment in User Mode.
3200K: The white balance is adjusted to 3200K illumination.
5600K: The white balance is adjusted to 5600K illumination.
ATW Speed (Slow 2, Slow 1, Mid, Fast 1, Fast 2) ATW Speed can be set.
Pedestal (-150 to +150) The black level (pedestal) of the luminance (Y) signal can be set. Used
in adjusting the black levels of two or more cameras.
Painting (-150 to +150)
R Gain, B Gain: Fine adjustment of the white balance can be made after AWC setting
when AWC A or AWC B is selected in White Balance Setting. The set value returns to
0 after AWC setting in using the camera alone.
R Pedestal, B Pedestal: Fine adjustment of the black balance can be made after ABC
setting. The set value returns to 0 after ABC setting in using the camera alone.
Table 33. G/L, Color Bar Settings
H Phase (-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.
SC Coarse (1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is supplied.
SC Fine (-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is supplied.
Color Bar Set (0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
Color Bar Set2 (0.0 IRE, 7.5 IRE) Set to 0.0 IRE for the SDI card.
±
±