Grass Valley 3-CCD CameraMan - Manual (Page 97)

CameraMan Installation and Operation Manual 97
Submenus Overview
Color Setting
Figure 68. Color Setting Submenu
Figure 69. G/L Color Bar Setting Submenu
Table 40. Color Settings
Chroma Level (-3 to +3) Chroma Level can be decreased or increased to any of
three levels each.
Flesh Tone (-3 to +3) Skin color can be decreased or increased to any of three
levels each.
White Bal ATW: The white balance is automatically adjusted to be always right.
AWC A, AWC B: Once the white balance is adjusted with the ITEM/
AWC switch on the back of the camera, it is not longer necessary to
set the white balance again if you simply select AWC A or AWC B,
provided that the camera is used under the same conditions. Fine
color adjustment can be made after setting AWC by red/blue gain
adjustment in user mode or from the RCU (RCB).
P SET 3200K: The white balance is adjusted to 3200K illumination.
P SET 5600K: The white balance is adjusted to 5600K illumination.
ATW Speed (Sow 2, Slow 1, Mid, Fast 1, Fast 2) ATW Speed can be set.
Highlight Chroma (OFF, Low, High) At Low or High, the color dynamic range widens to
prevent highlighted white portions from suppression.
Table 41. G/L Color Bar Settings
H Phase (-206 to +49) Horizontal phase can be adjusted
when a genlock signal is supplied.
SC Coarse (1, 2, 3, 4) Coarse adjustment of subcarrier
phase can be made when a genlock signal is
supplied.
SC Fine (-511 to +511) Fine adjustment of subcarrier
phase can be made when a genlock signal is
supplied.