Grass Valley 3-CCD CameraMan - Manual (Page 64)

64 CameraMan Installation and Operation Manual
Appendix I — CPT 2018-A3DP On-Screen Menus
Color Setting
Figure 40. Color Setting Submenu
G/L Color Bar Setting
Figure 41. G/L Color Bar Setting Menu
Table 15. Color Settings
Chroma Level (-3 to +3) Chroma Level can be decreased or increased to any of three levels each.
Flesh Tone (-3 to +3) Skin color can be decreased or increased to any of three levels each.
White Bal ATW: The white balance is automatically adjusted to be always right.
AWC A, AWC B: Once the white balance is adjusted with the ITEM/AWC switch on the back of the
camera, it is not longer necessary to set the white balance again if you simply select AWC A or
AWC B, provided that the camera is used under the same conditions. Fine color adjustment can
be made after setting AWC by red/blue gain adjustment in user mode or from the RCU (RCB).
P SET 3200K: The white balance is adjusted to 3200K illumination.
P SET 5600K: The white balance is adjusted to 5600K illumination.
ATW Speed (Slow 2, Slow 1, Mid, Fast 1, Fast 2) ATW Speed can be set.
Nega/Posi Posi: Normal image
Nega: Image is shown reversed in darkness and color.
Table 16. G/L Color Bar Settings
H Phase (-206 to +49) Horizontal phase can be adjusted when a genlock signal is supplied.
SC Coarse (1, 2, 3, 4) Coarse adjustment of subcarrier phase can be made when a genlock signal is supplied.
SC Fine (-511 to +511) Fine adjustment of subcarrier phase can be made when a genlock signal is supplied.