Grass Valley Aurora Browse v.6.0b Installation - Manual (Page 83)

September 22, 2006 Aurora Browse Installation and Configuration Guide 83
EDL Export, Save, Conform stage
Configure Profile MDI: Conform to air settings
This page configures the Managed Device Interface (MDI) for the Profile Media
Servers that record and store the high-res media. The MediaFrame system depends on
the Profile MDI to make high-res media assets visible across the system.
For the EDL stage, configure the settings related to the EDL Conform to air feature.
Specify one of more on-air Profiles as the targets to which conformed high-res clips
can be transferred for playout.
For other settings, refer to “Configure Profile MDIs” on page 60 .
B
a
sic
A
d
v
ance
d
D
o not
mo
di
fy
http://localhost:280 Profile MDI Access this page locally on the MDI server.
! Port 9100 is required. See “Ports and services mapping” on page 36 .
! All Domain names in the MediaFrame system must be identical.
! ! Saves changes. Changes are lost if you leave the configuration page without
updating.
! Select a Profile MDI.
! Enter the hostname of the Profile for the MDI selected above. a
a. Make sure the Profile name is entered just as it is in the host table.
! Enter the hostname of the backup Profile.
b
b.
Make sure the Profile name is entered just as it is in the host table.
! The time that the Profile MDI waits before it informs the MediaFrame system
that a clip has finished recording. Leave at 2.
! Automatically increments so each Profile MDI has a unique process port.
! ! Click to add as an existing managed device. For stand-alone Profile Media
Servers, add a MDI for each one. For Open SAN Profile Media Servers, add
only one MDI per Open SAN.
Verify the MDIs currently on-line. A listing for a single Profile MDI includes
the values from all four “Add Profile MDI” fields above.
! Click to remove the selected managed device.
The following settings specify Profiles to which material can be transferred via
Fibre Channel from other Profiles. This is used by Conform-To-Air EDL and
other Fibre Channel transfers.
! Select the MDI for a Profile to which material can be transferred.
! Hostname of the Profile specified above.
! Click to add as a transfer target. This makes the Profile available for selection
from the Aurora Browse application as a transfer destination.
Profiles capable of receiving a Fibre Channel transfer.
! Click to remove the selected transfer target.
Always click Update… buttons after making changes
To put changes into effect, start or restart Profile MDI Service on the MDI
server.