Grass Valley Aurora Browse v.6.0b Installation - Manual (Page 170)

170 Aurora Browse Installation and Configuration Guide September 22, 2006
Appendix B Legacy systems
2. From the Router Gateway host, click Start | Programs | Thomson | … | Diagnostic
Tools | Router Gateway Client . The Router Gateway Client application opens.
3. Configure as follows:
• IP: localhost
• Port: 8065 .
4. Click Connect . Verify that the Destinations and Sources drop-down lists are
populated, which means the connection is successful.
5. Configure as follows to trigger the router controller:
• Destinations: Select a destination from the list that is not the destination
currently used by the router.
• Sources: Select a source from the list that is not the source currently used by the
router
6. Monitor the video and audio currently routed. Click Take . Verify that the video and
audio changes.
7. Repeat previous steps to validate that takes work for all destinations that are
configured to an ingest channel.
Checklist: Router Gateway stand alone stage
Use the following check list to verify that the basic configuration and testing of the
Router Gateway stand alone stage is complete.
" The machine hosting the Router Gateway software component connects to the
router controller.
" The Router Gateway software component can change Destinations and Sources on
the router controller.