Grass Valley Aurora Browse v.6.0b Installation - Manual (Page 162)

162 Aurora Browse Installation and Configuration Guide September 22, 2006
Appendix B Legacy systems
• State: SUCCEEDED
8. In Event Viewer, verify informational messages regarding the creation of the
assets.
NOTE: If you've not yet configured the MDIs, you may get some error messages in
Event Viewer as the encoder attempts to communicate completion information to
MDI services. In this case these messages can be ignored.
9. In the Ingest Client application, click Get Assets . For both the high-res and the
low-res assets, look for the following report:
• COMPLETE_OK
10.On the Profile system, use Media Manager to verify that a clip with the correct
duration was created. Note the location of the clip, as it is used in configuration
stage tests later in this chapter.
11.On the NAS, use Windows Explorer to verify that the MPEG clip was created.
Open and play the clip. Validate video and audio.
Checklist: Encoder stand-alone stage
Use the following check list to verify that the basic configuration and testing of the
single-channel encoder is complete.
" Audio/Video/Timecode connected properly
" NetTime server running
" Profile(s) record high-res
" Encoder writes to NAS
" MPEG playback with audio