Grass Valley Aurora Browse v.6.0b Installation - Manual (Page 161)

September 22, 2006 Aurora Browse Installation and Configuration Guide 161
Test: Encoder stand-alone stage
3. Click Start | Programs | Thomson … | Ingest Client . The Ingest Client application
opens.
If you open the Ingest Client application on an operational system, you'll see the
status messages of the last encode job.
4. Configure as follows:
• Host Name or IP: localhost
• Port: 9330
5. Click Connect to establish a connection with the Ingest Control service that
controls the target Profile. Look for the following report in the Status area to verify
the connection:
• State: IDLE
6. Configure as follows to create a high-res and a low-res asset:
• Asset Name: Enter a name for the test asset you are about to create.
• Start Time: Enter ASAP. This starts recording immediately, similar to a crash
record. Or you can enter a start time a few minutes ahead of the current time.
• Duration: Enter 00.00.20.00 (this is 20 seconds, which is adequate for test
purposes)
7. Click Ingest . The ingest job is submitted and a ProNet session is established with
the Profile. Watch the reports in the Status area to verify that the creation of the
assets is progressing. Look for the following report to verify completion: