H3C Technologies H3C SecPath F1000-E - Manual (Page 75)

19
Select Connection > SSH > Auth from the navigation tree. The following window appears. Click
Browse… to bring up the file selection window, navigate to the private key file and click OK.
Figure 10 SSH client configuration interface 2)
In the window shown in
Figure 10 , click Open to connect to the server. If the connection is normal, you
will be prompted to enter the username. After entering the correct username (client002), you can enter
the configuration interface of the server.
SSH Client Configuration Examples
When Device Acts as Client for Password Authentication
Network requirements
• As shown in Figure 11 , Device A (the SSH client) needs to log into Device B (the SSH server) through
the SSH protocol. The username of the SSH client is client001 and the password is aabbcc.
• Password authentication is required. The username and password are saved on the SSH server.
Figure 11 Device acts as client for password authentication