H3C Technologies H3C SecPath F1000-E User Manual
Page 36
35
Figure 16 Portal server configuration
# Configure an IP address group.
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP
address group configuration page. Then, click Add to enter the page for adding an IP address group,
.
•
Input the name, start IP address, and end IP address of the IP address group. Note that the IP
address of Host must be within this IP address group.
•
Select whether to enable NAT. As NAT is not used in this example, select No for this field.
Figure 17 Add an IP address group
# Add a portal device.
Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Then, click Add to enter the page for adding a portal device, as shown in
.
•
Type the device name Device.
•
Type the IP address of Device’s interface that connects to the host.
•
Type the key, which must be the same as that configured on Device.
•
Set whether to enable IP address reallocation. Direct portal authentication is used in this example,
and therefore select No from the Reallocate IP drop-down list.
•
Select Yes for both Support Server Heartbeat and Support User Heartbeat.