Configuration considerations, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 35
34
Figure 15 Network diagram for configuring portal server detection and portal user synchronization
Device
Host
2.2.2.2/24
Gateway : 2.2.2.1/24
GE0/2
2.2.2.1/24
GE0/1
192.168.0.100/24
Portal server
192.168.0.111/24
RADIUS server
192.168.0.112/24
Configuration considerations
Step1
Configure the portal server and enable portal server heartbeat function and the portal user heartbeat
function.
Step2
Configure the RADIUS server to implement authentication and accounting.
Step3
Configure direct portal authentication on interface GigabitEthernet 0/2, which is directly connected with
the host.
Step4
Configure the portal server detection function on the access device, so that the access device can detect
the status of the portal server by cooperating with the portal server heartbeat function.
Step5
Configure the portal user information synchronization function, so that the access device can synchronize
portal user information with the portal server by cooperating with the portal user heartbeat function.
Configuration procedure
NOTE:
•
Configure IP addresses for the host, Device, and servers as shown in
and ensure that they can
reach each other.
•
Perform configurations on the RADIUS server to ensure that the user authentication and accounting
functions can work normally.
Step1
Configure the portal server on the iMC
NOTE:
The following describes how to configure the portal server on the iMC. iMC PLAT 3.20-R2602P06 and
iMC UAM 3.60-E6203 are used in this example.
# Configure the portal server.
Log on to the iMC management platform and select the Service tab. Then, select Portal Service
Management > Server from the navigation tree to enter the portal server configuration page, as
shown in
.
•
Configure the portal server heartbeat interval and user heartbeat interval.
•
Input the URL address of the portal authentication main page, in the format of http://ip:port/portal,
where ip and port are those configured during installation of the iMC UAM. Usually, the default
setting of port 8080 is used.