H3C Technologies H3C SecPath F1000-E - Manual (Page 70)

14
Figure 3 SSH client configuration interface
In the window shown in
Figure 3 , click Open to connect to the server. If the connection is normal, you
will be prompted for the username and password. After entering the correct username (client001) and
password (aabbcc), you can enter the configuration interface of the server.
When Device Acts as Server for Publickey Authentication
Network requirements
• The host (the SSH client) and Device (the SSH server) are directly connected through the Ethernet
interfaces.
• The host runs SSH2.0 client software to log into Device for configuration.
• Publickey authentication is used, and the public key algorithm is RSA.
Figure 4 Device acts as server for publickey authentication
Configuration procedure