H3C Technologies H3C SecPath F1000-E - Manual (Page 19)

18
NOTE:
•
You need to configure IP addresses for the host, Device, and servers as shown in Figure 4 and ensure
that they can reach each other.
• Perform configurations on the RADIUS server to ensure that the user authentication and accounting
functions can work normally.
Step1 Configure the portal server
NOTE:
The following describes how to configure the portal server on the iMC. iMC PLAT 3.20-R2602 and iMC
UAM 3.60-E6102 are used in this example.
# Configure the portal server.
Log on to the iMC management platform and select the Service tab. Then, select Portal Service
Management > Server from the navigation tree to enter the portal server configuration page, as
shown in
Figure 5 .
• Input the URL address of the portal authentication main page, in the format of http://ip:port/portal,
where ip and port are those configured during the iMC UAM installation. Usually, the default
setting of port 8080 is used.
Figure 5 Portal server configuration
# Configure the IP address group.
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP
address group configuration page. Then, click Add to enter the page for adding an IP address group,
as shown in Figure 6 .
• Input the name, start IP address, and end IP address of the IP address group. Note that the IP
address of Host (2.2.2.2) must be in the IP address range of this group.