H3C Technologies H3C MSR 50 - Manual (Page 95)

Configuring ACS attributes
ACS attributes include ACS URL, username and password. When the CPE initiates a connection to the
ACS, the ACS URL, username and password are carried in the connection request. After the ACS receives
the request, if the parameter values in the request are consistent with those configured locally, the
authentication succeeds, and the connection is allowed to be established. If not, the authentication fails,
and the connection is not allowed to be established.
Configuring the ACS URL
You can assign only one ACS for a CPE and the ACS URL you configured overwrites the old one, if any.
To configure the ACS URL:
Step Command Remarks
179. Enter system view. system-view N/A
180. Enter CWMP view. cwmp N/A
By default, no ACS URL is
configured.
181. Configure the ACS URL. cwmp acs url url
Configuring the ACS username and password
To pass ACS authentication, make sure the configured username and password are the same as those
configured for the CPE on the ACS.
To configure the ACS username and password:
Step Command Remarks
182. Enter system view. system-view N/A
183. Enter CWMP view. cwmp N/A
By default, no ACS username is
configured for connection to the
ACS.
184. Configure the ACS username
for connection to the ACS.
cwmp acs username username
Optional.
You can specify a username
without a password for
authentication, but must make sure
the ACS has the same
authentication setting as the CPE.
185. Configure the ACS password
for connection to the ACS. cwmp acs password [ cipher |
simple ] password
By default, no ACS password is
configured for connection to the
ACS.
82