H3C Technologies H3C MSR 50 - Manual (Page 111)

Configuration procedure
To configure NetStream aggregation data export:
Step Command Remarks
236. Enter system view. system-view N/A
interface interface-type
interface-number
237. Enter interface view. N/A
238. Enable NetStream. ip netstream { inbound | outbound } Disabled by default.
239. Exit to system view. quit N/A
ip netstream aggregation { as |
destination-prefix | prefix |
prefix-port | protocol-port |
source-prefix | tos-as |
tos-destination-prefix | tos-prefix |
tos-protocol-port | tos-source-prefix
| tos-bgp-nexthop }
240. Set a NetStream
aggregation mode and
enter its view. N/A
By default, no destination address or
destination UDP port number is
configured in NetStream
aggregation view.
241. Configure the
destination address and
the destination UDP port
number for the
NetStream aggregation
data export.
ip netstream export host ip-address
udp-port [ vpn-instance
vpn-instance-name ]
If you expect to export only
NetStream aggregation data,
configure the destination address in
related aggregation view only.
Optional.
By default, the interface connecting
to the NetStream server is used as the
source interface.
• Source interfaces in different
aggregation views can be
different.
242. Configure the source
interface for NetStream
aggregation data
export.
ip netstream export source interface
interface-type interface-number
• If no source interface is
configured in aggregation view,
the source interface configured in
system view, if any, is used.
• H3C recommends you connect
the network management
interface to the NetStream server.
243. Enable the NetStream
aggregation
configuration.
enable Disabled by default.
98