H3C Technologies H3C MSR 50 - Manual (Page 146)

[DeviceA-nqa-admin-test1-ftp] filename config.txt
# Enable the saving of history records.
[DeviceA-nqa-admin-test1-ftp] history-record enable
[DeviceA-nqa-admin-test1-ftp] quit
# Start the FTP operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# Stop the FTP operation after a period of time.
[DeviceA] undo nqa schedule admin test1
# Display the results of the FTP operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 173/173/173
Square-Sum of round trip time: 29929
Last succeeded probe time: 2011-11-22 10:07:28.6
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history records of the FTP operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history record(s):
Index Response Status Time
1 173 Succeeded 2011-11-22 10:07:28.6
The output shows that Device A uses 173 milliseconds to upload a file to the FTP server.
HTTP operation configuration example
Network requirements
As shown in Figure 42 , configure an HTTP operation on the NQA client to test the time required to obtain
data from the HTTP server.
Figure 42 Network diagram
133