H3C Technologies H3C MSR 50 - Manual (Page 127)

Step Command Remarks
295. Enter system view. system-view N/A
296. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag By default, no NQA operation is
created.
297. Specify the UDP jitter type
and enter its view.
type udp-jitter N/A
By default, no destination IP
address is configured.
298. Configure the destination
address of UDP packets.
destination ip ip-address The destination IP address must be
the same as that of the listening
service on the NQA server.
By default, no destination port
number is configured.
299. Configure the destination port
of UDP packets.
destination port port-number The destination port must be the
same as that of the listening service
on the NQA server.
Optional.
300. Specify the source port
number of UDP packets.
source port port-number By default, no source port number
is specified.
Optional. 301. Configure Payload size in
each UDP packet.
data-size size
100 bytes by default.
Optional.
302. Configure the string to be
filled in the payload of each
UDP packet.
By default, the string is the
hexadecimal number
00010203040506070809.
data-fill string
303. Configure the number of UDP
packets sent in one UDP jitter
probe.
probe packet-number Optional.
packet-number 10 by default.
Optional. 304. Configure the interval for
sending UDP packets. probe packet-interval
packet-interval
20 milliseconds by default.
305. Configure how long the NQA
client waits for a response
from the server before it
regards the response times
out.
Optional.
probe packet-timeout
packet-timeout
3000 milliseconds by default.
Optional.
By default, no source IP address is
specified.
306. Configure the source IP
address for UDP packets.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no UDP packets can be
sent out.
source ip ip-address
114