H3C Technologies H3C MSR 50 - Manual (Page 110)

Step Command Remarks
228. Configure NetStream
sampling. ip netstream sampler sampler-name { inbound |
outbound }
Disabled by default.
Configuring NetStream data export
To allow the NDE to export collected statistics to the NetStream server, configure the source interface out
of which the data is sent and the destination address to which the data is sent.
Configuring NetStream traditional data export
Step Command Remarks
229. Enter system view. system-view N/A
230. Enter interface view. interface interface-type interface-number N/A
231. Enable NetStream. ip netstream { inbound | outbound } Disabled by default.
232. Exit to system view. quit N/A
233. Configure the destination
address and the destination
UDP port number for the
NetStream traditional data
export.
By default, no destination
address or destination UDP
port number is configured,
so the NetStream traditional
data is not exported.
ip netstream export host ip-address
udp-port [ vpn-instance
vpn-instance-name ]
Optional.
By default, the interface
where the NetStream data
is sent out (the interface
connects to the NetStream
server) is used as the source
interface. 234. Configure the source interface
for NetStream traditional data
export.
ip netstream export source interface
interface-type interface-number
H3C recommends that you
connect the network
management interface to
the NetStream server and
configure it as the source
interface.
Optional.
235. Limit the data export rate. ip netstream export rate rate
No limit by default.
Configuring NetStream aggregation data export
NetStream aggregation can be implemented by software.
Configuration restrictions and guidelines
Configurations in NetStream aggregation view apply to aggregation data export only, and those in
system view apply to NetStream traditional data export. If configurations in NetStream aggregation view
are not provided, the configurations in system view apply to the aggregation data export.
97