H3C Technologies H3C MSR 50 - Manual (Page 128)

NOTE:
The display nqa history command does not show the results of the UDP jitter operation. Use the display
nqa result command to display the results, or use the display nqa statistics command to display the
statistics of the operation.
Configuring an SNMP operation
An SNMP operation measures the time the NQA client uses to get a value from an SNMP agent.
To configure an SNMP operation:
Step Command Remarks
307. Enter system view. system-view N/A
308. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag By default, no NQA operation is
created.
309. Specify the SNMP type and
enter its view.
type snmp N/A
310. Configure the destination
address of SNMP packets.
By default, no destination IP
address is configured.
destination ip ip-address
Optional.
311. Specify the source port of
SNMP packets.
source port port-number By default, no source port number
is specified.
Optional.
By default, no source IP address is
specified.
312. Configure the source IP
address of SNMP packets.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no SNMP packets can
be sent out.
source ip ip-address
Configuring a TCP operation
A TCP operation measures the time the NQA client uses to establish a TCP connection to a specific port
on the NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see " Configuring the NQA server ."
To configure a TCP operation:
Step Command Remarks
313. Enter system view. system-view N/A
115