H3C Technologies H3C MSR 50 - Manual (Page 102)

89
Figure 30 Network diagram
Configuration procedure
The two hosts can be replaced by other types of network devices such as routers.
1. Configure the router:
# Enable IP accounting.
system-view
[Router] ip count enable
# Configure an IP accounting rule.
[Router] ip count rule 1.1.1.1 24
# Set the timeout time to 1440 minutes (24 hours).
[Router] ip count timeout 1440
# Set the maximum number of flow entries in the interior table to 100.
[Router] ip count interior-threshold 100
# Set the maximum number of flow entries in the exterior table to 20.
[Router] ip count exterior-threshold 20
# Assign Ethernet 1/1 an IP address, and enable IP accounting for both incoming and outgoing IP
packets on it.
[Router] interface ethernet 1/1
[Router-Ethernet1/1] ip address 1.1.1.2 24
[Router-Ethernet1/1] ip count inbound-packets
[Router-Ethernet1/1] ip count outbound-packets
[Router-Ethernet1/1] quit
# Assign Ethernet 1/2 an IP address.
[Router] interface ethernet 1/2
[Router-Ethernet1/2] ip address 2.2.2.1 24
[Router-Ethernet1/2] quit
2. Configure a static route on Host A and Host B respectively so that they can reach each other.
(Details not shown.)
3. Display IP accounting statistics on the router.
[Router] display ip count inbound-packets interior
1 Inbound streams information in interior list:
SrcIP DstIP Protocol Pkts Bytes
1.1.1.1 2.2.2.2 ICMP 4 240
[Router] display ip count outbound-packets interior
1 Outbound streams information in interior list:
SrcIP DstIP Protocol Pkts Bytes
2.2.2.2 1.1.1.1 ICMP 4 240