H3C Technologies H3C MSR 50 - Manual (Page 16)

Task Remarks
Configuring SNMP traps Optional.
Configuring SNMP basic parameters
SNMPv3 differs from SNMPv1 and SNMPv2c in many ways. Their configuration procedures are
described in separate sections.
Configuring SNMPv3 basic parameters
Step Command Remarks
1. Enter system view. system-view N/A
Optional.
By default, the SNMP agent is
disabled.
You can also enable the SNMP
agent by using any command that
begins with snmp-agent except for
the snmp-agent
calculate-password command.
2. Enable the SNMP agent. snmp-agent
Optional.
The defaults are as follows:
snmp-agent sys-info { contact
sys-contact | location sys-location
| version { all | { v1 | v2c |
v3 }* } }
• Contact—R&D Hangzhou,
Hangzhou H3C Technologies
Co., Ltd.
3. Configure system information
for the SNMP agent.
• Location—Hangzhou China.
• Version—SNMPv3.
Optional.
The default local engine ID is the
company ID plus the device ID.
snmp-agent local-engineid
engineid
4. Configure the local engine ID.
After you change the local engine
ID, the existing SNMPv3 users
become invalid, and you must
re-create the SNMPv3 users.
3