H3C Technologies H3C MSR 50 - Manual (Page 205)

Step Command Remarks
493. Enter system view. system-view N/A
Optional.
494. Enable the information center. info-center enable
Enabled by default.
Optional.
info-center channel
channel-number name
channel-name
495. Name the channel with a
specified channel number.
See Table 6 for default channel
names.
Optional.
info-center trapbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
496. Configure an output channel
for the trap buffer and set the
buffer size.
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
497. Configure an output rule for
the trap buffer.
See "Default output rules of system
information."
Optional.
498. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
The timestamp format for log, trap
and debug information is date by
default.
Outputting system information to the log buffer
The log buffer only receives log information, and discards trap and debug information.
To output system information to the log buffer:
Step Command Remarks
499. Enter system view. system-view N/A
Optional.
500. Enable the information center. info-center enable
Enabled by default.
Optional.
info-center channel
channel-number name
channel-name
501. Name the channel with a
specified channel number.
See Table 6 for default channel
names.
Optional.
info-center logbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
502. Configure an output channel
for the log buffer and set the
buffer size.
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is 512.
192