H3C Technologies H3C MSR 50 - Manual (Page 84)

Step Command Remarks
169. Configure the SNMP
community name shared by a
cluster.
cluster-snmp-agent community
{ read | write } community-name
[ mib-view view-name ]
N/A
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ]
170. Configure the SNMPv3 group
shared by a cluster.
N/A
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
171. Create or update information
about the MIB view shared by
a cluster.
cluster-snmp-agent mib-view
included view-name oid-tree
cluster-snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 |
sha } [ cipher | simple ]
auth-password ] [ privacy-mode
des56 [cipher | simple ]
priv-password ]
172. Add a user for the SNMPv3
group shared by a cluster.
N/A
Configuring Web user accounts in batches
Configuring Web user accounts in batches enables you to do the following:
• Through the Web interface, configure, on the management device, the username and password
used to log in to the cluster devices (including the management device and member devices).
• Synchronize the configurations to the member devices on the whitelist.
This operation is equal to performing the configurations on the member devices. You need to enter your
username and password when you log in to the devices (including the management device and member
devices) in a cluster through Web.
These Web user account settings are retained on the member devices after they are removed from the
whitelist or the cluster is dismissed.
To configure Web user accounts in batches:
Step Command
173. Enter system view. system-view
174. Enter cluster view. cluster
cluster-local-user user-name [ password { cipher |
simple } password ]
175. Configure Web user accounts in batches.
71