H3C Technologies H3C MSR 50 - Manual (Page 36)

multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 7 :
dropevents : 0 , octets : 766
packets : 7 , broadcast packets : 0
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 8 :
dropevents : 0 , octets : 1154
packets : 13 , broadcast packets : 1
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions
: 0 , utilization : 0
# On the configuration terminal, get the traffic statistics through SNMP. (Details not shown.)
Alarm group configuration example
Network requirements
Configure the RMON alarm group on the RMON agent in Figure 9 to send alarms in traps when the
5-second incoming traffic statistic on Ethernet 1/1 crosses the rising threshold or drops below the falling
threshold.
Figure 9 Network diagram
Configuration procedure
# Configure the SNMP agent with the same SNMP settings as the NMS at 1.1.1.2. This example uses
SNMPv1, read community public, and write community private.
system-view
[Sysname] snmp-agent
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
[Sysname] snmp-agent sys-info version v1
[Sysname] snmp-agent trap enable
23