H3C Technologies H3C MSR 50 - Manual (Page 231)

Step Command Remarks
ipv6 netstream { inbound
Disabled by default. 545. Enable IPv6 NetStream.
| outbound }
546. Exit to system view. quit N/A
547. n
e
destination UDP port
number for the IPv6
ipv6 netstream export
host ip-address udp-port
[ vpn-instance
By default, no destination address or destination
umber is configured, so the IPv6
Configure the destinatio
address and th
UDP port n
NetStream traditional data is not exported.
NetStream traditional
data export.
vpn-instance-name ]
548. Configure the source
interface for IPv6
NetStream traditional
ipv6 netstream export
source interface
ts to the
NetStream server) is used as the source interface.
Optional.
By default, the interface where the NetStream
data is sent out (the interface that connec
interface-type
interface-number H3C recommends that you connect the network
e to the NetStream server
and configure it as the source interface.
data export.
management interfac
549. Limit the data export rate. ipv6 netstream export
rate rate
Optional.
No limit by default.
Configuring IPv6 NetStream aggregation data export
Configur
Pv6 NetStream aggregation view apply to aggregation data export only, and those in
ons in IPv6 NetStream aggregation view are
egation data export.
Configuration procedure
T tion data export:
Ste
IPv6 NetStream aggregation can be implemented by software.
ation restrictions and guidelines
Configurations in I
system view apply to traditional data export. If configurati
ot provided, the configurations in system view apply to the aggr n
o configure IPv6 NetStream aggrega
p Command Remarks
550. Enter system view. system-view N/A
551. Enter interface
view.
interface-type interface-number interface N/A
552. Enable IPv6
NetStream.
ipv6 netstream { inbound | outbound } Disabled by default.
553. Exit to system
view.
quit N/A
554. 6
NetStream
aggregation
mode and enter
its view.
ipv6 netstream aggregation { as |
bgp-nexthop | destination-prefix |
prefix | protocol-port | source-prefix }
Set an IPv
N/A
218