H3C Technologies H3C MSR 50 - Manual (Page 133)

Step Command Remarks
343. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag By default, no NQA operation is
created.
344. Specify the DLSw type and
enter its view.
type dlsw N/A
345. Configure the destination
address of probe packets.
By default, no destination IP
address is configured.
destination ip ip-address
Optional.
By default, no source IP address is
specified.
346. Configure the source IP
address of probe packets.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no probe packets can
be sent out.
source ip ip-address
Configuring optional parameters for an NQA operation
Unless otherwise specified, the following optional parameters apply to all NQA operation types.
To configure optional parameters for an NQA operation:
Step Command Remarks
347. Enter system view. N/A system-view
348. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag By default, no NQA operation is
created.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
349. Enter a specified NQA
operation type view.
N/A
Optional.
350. Configure a description. description text By default, no description is
configured.
Optional.
By default, the interval between
two consecutive voice tests is
60000 milliseconds. For other
tests, the interval is 0 milliseconds.
Only one operation is performed.
351. Specify the interval at which
the NQA operation repeats.
frequency interval
If the operation is not completed
when the interval expires, the next
operation does not start.
120