Outputting system information to the snmp module – H3C Technologies H3C MSR 50 User Manual
Page 206
Step Command
Remarks
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
503.
Configure an output rule for
the log buffer.
See "Default output rules of system
information."
Optional.
504.
Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
The timestamp format for log, trap
and debug information is date by
default.
Outputting system information to the SNMP module
The SNMP module only receives trap information, and discards log and debug information.
To monitor the device running status, trap information is usually sent to the SNMP network management
system (NMS). For this purpose, you must configure output of traps to the SNMP module, and set the trap
sending parameters for the SNMP module. For more information about SNMP, see "Configuring SNMP."
To output system information to the SNMP module:
Step Command
Remarks
505.
Enter system view.
system-view
N/A
Optional.
506.
Enable the information center. info-center enable
Enabled by default.
Optional.
info-center channel
channel-number name
channel-name
507.
Name the channel with a
specified channel number.
for default channel
names.
Optional.
info-center snmp channel
{ channel-number |
channel-name }
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
508.
Configure an output channel
for the SNMP module.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap
{ level severity | state state }* ]*
Optional.
509.
Configure an output rule for
the SNMP module.
See "Default output rules of system
information."
Optional.
510.
Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
The timestamp format for log, trap
and debug information is date by
default.
193