Ntp multicast mode configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 50 User Manual
Page 59
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 31.00 ms
Root dispersion: 8.31 ms
Peer dispersion: 34.30 ms
Reference time: 16:01:51.713 UTC Sep 19 2005 (C6D95F6F.B6872B02)
The output shows that Router A has synchronized to Router C. The stratum level of Router A is 3,
and that of Router C is 2.
# Display NTP session information for Router A, which shows that an association has been set up
between Router A and Router C.
[RouterA-Ethernet1/1] display ntp-service sessions
source reference stra reach poll now offset delay disper
**************************************************************************
[1234] 3.0.1.31 127.127.1.0 2 254 64 62 -16.0 32.0 16.6
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
NTP multicast mode configuration example
Network requirements
As shown in
, Router C functions as the NTP server for multiple devices on different network
segments and synchronizes the time among multiple devices.
•
Router C’s local clock is to be used as a reference source, with the stratum level 2.
•
Router C operates in multicast server mode and sends multicast messages from Ethernet 1/1.
•
Router D and Router A operate in multicast client mode and receive multicast messages through
their respective Ethernet 1/1.
Figure 20 Network diagram
Configuration procedure
1.
Set the IP address for each interface as shown in
. (Details not shown.)
2.
Configure Router C:
46