H3C Technologies H3C MSR 50 - Manual (Page 132)

Step Command Remarks
Optional.
By default, no source IP address is
specified.
335. Specify the source IP address
of voice packets.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no voice packets can
be sent out.
source ip ip-address
Optional.
336. Specify the source port
number of voice packets.
source port port-number By default, no source port number
is specified.
Optional.
By default, the voice packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law
codec type, and 32 bytes for
G.729 A-law codec type.
337. Configure Payload size in
each voice packet.
data-size size
Optional.
338. Configure the string to be
filled in the payload of each
voice packet.
By default, the string is the
hexadecimal number
00010203040506070809.
data-fill string
339. Configure the number of voice
packets to be sent in a voice
probe.
Optional. probe packet-number
packet-number
1000 by default.
Optional. 340. Configure the interval for
sending voice packets. probe packet-interval
packet-interval
20 milliseconds by default.
341. Configure how long the NQA
client waits for a response
from the server before it
regards the response times
out.
Optional. probe packet-timeout
packet-timeout
5000 milliseconds by default.
NOTE:
The display nqa history command cannot show the results of the voice operation. Use the display nqa
result command to display the results, or use the display nqa statistics command to display the statistics of
the operation.
Configuring a DLSw operation
A DLSw operation measures the response time of a DLSw device.
To configure a DLSw operation:
Step Command Remarks
342. Enter system view. system-view N/A
119