Use the device default ip address, Manually adjust the ip address of the pc – ACTi V11 User Manual
Page 9
Encoder Firmware User
’s Manual H1.02.30
Use the Device Default IP Address
If there is no DHCP server in the given network, the user may have to assign the IP addresses to
both PC and device manually to make sure they are in the same network segment.
When the device is plugged into network and it does not detect any DHCP services, it will
automatically assign itself a default IP:
192.168.0.100
Whereas the default port number would be
80
. In order to access that device, the IP address of
the PC has to be configured to match the network segment of the device.
Manually Adjust the IP Address of the PC
In the following example, based on Windows 7, we will configure the IP address to
192.168.0.99
and set Subnet Mask to
255.255.255.0
by using the steps below:
1
2
3
4