Motion detection – ACTi V11 User Manual
Page 48
Encoder Firmware User
’s Manual H1.02.30
Motion Detection
The
Motion Detection
section allows the user to configure the video motion detection system of
the device. Motion detection regions are based on the Stream 1. By default, there are three (3)
enabled pre-defined regions. For multiple channel devices, select the channel from the
drop-down box to set its motion detection.
Click
Setup
to adjust the motion detection regions or its parameters.
NOTE:
Microsoft Internet Explorer
browser is required to configure the motion detection
regions.
There are three independently configurable motion detection regions in the device.
Each
motion detection region has 6 configuration parameters:
Enabled or disabled
Location of the region
Size of the region
Sensitivity
Trigger threshold
Trigger interval