beautypg.com

What responses will occur – ACTi V11 User Manual

Page 74

background image

www.acti.com

Encoder Firmware User

’s Manual H1.02.30

74

Video Recovery:

This event is triggered when the analog video input is detected by the encoder.

A common scenario is for the encoder to activate a DO signal such as a light to indicate that video

is being viewed.

Device boots successfully

: This will trigger the event responses once the device boots up. You

can use this to create a notification system that keeps record of when the device has been

rebooted via email.

Reboot device

: This triggers the event response when the device is shut down via web UI

“Save

and Reboot

”. Use this to keep record of when was the device setting edited. Note that this will not

take effect when the device is unplugged, as this is not normal shutdown.

Fail to write storage

(with storage card only): Trigger occurs when there is an error in writing

data to the memory card.

Remove storage media

(with storage card only): Trigger occurs when the memory card is

suddenly removed from the device.

What Responses Will Occur?

Available responses vary depending on what triggered the event.

Digital Output

: This is a useful link to other devices. Click to include this in the response for this

rule. Select the digital output and make sure to configure it on the

Event Configuration

page.

Send notification Message

: Select from the three pre-defined messages which you

’ve setup in

the Event Configuration section. You may enable multiple messages at the same time. For

sending Email, please limit the recipient to one per event rule. If you need to send email to more

than one recipient, please use separate event rules triggered by the same trigger.

Upload video/snapshots and Audio

: Select which of the event configurations to include in this

response set. If you are sending email via upload video and sending notification message at the

same time, the system will automatically merge the two emails into one. The subject and image

will be based upon the Upload snapshot Event configuration enabled, but the message in the

This manual is related to the following products: