Serial setting – ACTi V11 User Manual
Page 22
Encoder Firmware User
’s Manual H1.02.30
Copy the first GPS coordinates from the URL bar and paste it on
Degree of Latitude
. Copy the
second part of the GPS coordinates to
Degree of Longitude
.
Press
Apply
to save the changes.
After changing any of the items above, click
Apply
to save the changes. The Reset button
undoes the changes that had just been made but not applied yet.
Serial Setting
The
Serial Setting
section allows the user to set the serial port configurations of the encoder to
synchronize it with the serial port configurations of the PT device. For multi-channel encoders,
since all video channels will share one serial port, the serial port configurations on all the
connected devices must have the same serial port configurations.
Serial Port Control:
Select the serial port control that matches with the serial port configured on
the PT device. This function is equivalent to the DIP switch of the PT device.
Seral Port Baud Rate:
Select the serial port baud rate that matches with the baud rate set on the
PT device.
PTZ Vendor/Protocol:
ACTi devices and video management systems fully support the URL
Command, a high level PT command set. However, in case the devices will be used with devices
from third party vendors that only support Serial Hex Command (low level PT command set),
users must select the
PTZ Vendor/Protocol
to use. Otherwise, leave the default settings.
After changing any of the items above, click
Apply
to save the changes. The
Reset
button
undoes the changes that had just been made but not applied yet.