ACTi V11 User Manual
Page 27
Encoder Firmware User
’s Manual H1.02.30
Allowed
mode will refuse access to all IP addresses except the ones listed below.
Blocked
mode will accept all incoming access except the IP addresses listed below.
Using
Netmask
(Subnet Mask) allows you to set filtering for a whole range of IP address at once,
without the need to enter all of them individually. If you are not sure about the function of Netmask,
then you should use 255.255.255.255, and it will affect only a single IP address per line of entry,
or use 255.255.255.0 to use the same setting for all IP addresses starting with the same three
numbers. .
After changing any of the items above, click
Apply
to save the changes. The
Reset
button
undoes the changes that had just been made but not applied yet.
Warning!
Do not accidentally block your own IP address that you are connecting from; otherwise
you will not be able to access the device any more to undo the changes. If this happens by
mistake, you can do the hardware reset
– it will clear all the filtering rules.