ACTi V11 User Manual
Page 42
Encoder Firmware User
’s Manual H1.02.30
Most installation projects include clear network topology and static IP addresses for each device.
In such cases, you can change the device to
Static IP Address
mode and modify the
IP
Address, Subnet Mask
and
Gateway
accordingly.
In some rare cases, the device may be connected to the control center over Internet. Usually, the
most cost efficient way is to use ADSL connection with
PPPoE
. To avoid the unexpected changes
of IP addresses by Internet Service Provider upon the restart of the device, it is recommended to
activate a DDNS service for such scenario, and let the control center connect to the device by the
domain name instead. Please refer to the DDNS section for more details.
To set the device in PPPoE mode, set the button to
PPPoE
and key in the
User Name
and
Password
, provided by Internet Service Provider.
After changing any of the items above, click
Apply
to save the changes. The
Reset
button
undoes the changes that had just been made but not applied yet.
The new IP address settings will only take effect after clicking
System -> Save & Reboot
.