How is it triggered – ACTi V11 User Manual
Page 73
Encoder Firmware User
’s Manual H1.02.30
In the example below, the event handler rule is active 24 hours a day, 7 days a week.
How is It Triggered?
Events may be triggered by one of the several sources. In the example below, Motion Detection
region 1 is used as the event trigger.
You may also ask the event to be repeatedly triggered during this scheduled time. The interval is
determined in minutes. You may use this with email / FTP upload to take snapshots at regular
intervals.
Scheduler
: The trigger occurs on the specified time. Set the frequency of the occurence in
Occur Every
(minutes).
DIs
: The device may be triggered by a digital input. Select the digital input and make sure to
configure it on the
Event Configuration
page.
Motion
: You may trigger the event if one or many Motion Detection regions encounter a motion
trigger. Trigger from any of them will initiate the event. The duration of event will be the same as
the MD trigger length, or the Trigger interval time, defined in the Motion Detection section on
Video Adjust page.
Video Loss:
This
event is triggered when the analog video input is disconnected, which makes
the video status as “lost”. The video status returns to “normal” when the device receives the
analog video signal. A common scenario is for the encoder to send an email to the adminstrator
when the video signal is lost, and activate the DO signal to alarm that persists until the analog
signal is restored.