ACTi V11 User Manual

Page 66

Encoder Firmware User

’s Manual H1.02.30

Notification Message

Notification messages

may be sent to either an email or a HTTP CGI server. If sent to a CGI

server, it works the same as an URL command, but it does not allow a second message at end of

event. You may configure up to three preset massages. You can configure a message, but

disable it. This will allow you to keep the settings without using it, which will be useful in testing

and troubleshooting.

To setup Notification Messages, make sure to enable the message and then determine what type

of message to send (HTTP CGI or email).

If you are sending to CGI server, you need to enter the CGI path, the URL command itself, and an

optional message.

If you are sending email, please enter the recipient E-Mail address, the email subject, and the

body message.

After changing any of the items above, click

Apply

to save the changes. The

Reset

button

undoes the changes that had just been made but not applied yet.

*Pre-requisites: SMTP server / HTTP CGI server setup.

This manual is related to the following products: