Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 - Manual (Page 56)

46

Parameters and Options WAVECOM Monitoring System W-SPECTRA, W-SPEED Manual V1.1.0
- TELX_MM: Multi message monitoring, the mode stays on the TDM channel until there are no
more Telex transmissions on this channel.
 Server: Set the Windows directory for the output files on the server.
 Client: Set the Windows directory for the output files on the client computer. This setting is only
enabled on a remotely-connected GUI.
 Watchlist: Click the All MES IDs box, if all MESs must be monitored; leave this box empty if only
specific MESs should be monitored. Enter these MES IDs into the combo box. If ranges of MES IDs
should be monitored, enter and enable each range.
See “ SAT System ” on page 219.
Timestamp
By clicking Timestamps in the lower right corner of the W-SPECTRA GUI, the local time will be displayed
beside each output line.
Click the “Timestamp” button to turn on and off the timestamp in the result display.
Display Results in a Separate Window
By clicking Window button in the lower right corner of the W-SPECTRA GUI, a separate window will open
to display the decoding result. This is helpful, because the result display window in W-SPECTRA may be
quite small.
Click the “Window” button will open a separate window to display the result.