Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 - Manual (Page 40)

30

Complete Automatic Monitoring System W-SPECTRAWAVECOM Monitoring System W-SPECTRA, W-
SPEED Manual V1.1.0
The first 6 database fields are mandatory. The use can define his own database template in the Configura-
tion menu “Customize a database” by choosing from the 23 optional fields and defining his own database
fields (up to three).
Define a database template.
In all three W-SPECTRA operation modes the user can open his customised database template to capture
monitoring results manually or automatically.
Three Operation Modes
W-SPECTRA works in 3 operation modes: Direct mode, Memory scan and Frequency search. All three
modes can work in an automatic or a manual way. The user can select a signal by placing the middle fre-
quency tuning cursor in the narrowband spectrum display and turn on a classifier or a decoder. Results are
displayed in the lower part of the Operation tab. In each mode W-SPECTRA opens a database in a user de-
fined template to capture the monitoring results.
Direct Mode
– Begin the Spectrum Monitoring
W-SPECTRA “Direct mode” is designed for a user to begin the spectrum monitoring mainly in a manual
way.
 The user can set the receiver frequency manually and turn on a classifier or a decoder to monitor
and decode a signal.
 To select a signal the user can move the middle frequency tuning cursor in the narrowband spec-
trum display. Please note that for HF, VHF/UHF-SUB decoders or classifier the signal should ap-
pear at the right side of the middle cursor; for VHF/UHF-DIR and SAT decoders or classifier the
middle tuning cursor should be placed in the middle of the signal.
 The user can manually insert results into a database by clicking “Insert” or “Overwrite” button in
the Operation tab. The user can also edit a database entry by clicking the “Edit” button in the Op-
eration tab.
 All database entries are displayed in the “Direct mode” tab.