Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 - Manual (Page 191)

WAVECOM Monitoring System W-SPECTRA, W-SPEED Manual V1.1.0 Transmission Modes

181
Parameter Value
Signal source(s) AF, IF
The KG-84 bit stream contains a 64 bits long header followed by two 256 bit message blocks in turn fol-
lowed by encrypted data terminated by an End-Of-Message. Hence synchronization can only be achieved
at the start of transmission using the KG-84 header.
The length of a message is variable. Messages are usually sent consecutively with a short idle sequence
between each message.
STANAG-4481-PSK
This STANAG mode is specified by the NATO (North Atlantic Treaty Organization) Military Agency for
Standardization as a "Minimum technical equipment standards for naval HF shore-to-ship broadcast sys-
tem".
Parameter Value
Frequency range HF
Operation modes Broadcast/Simplex FEC
Modulation BPSK
Symbol rate 2400 Bd
Receiver settings Data, CW, USB, LSB
Signal source(s) AF, IF
The modulation technique used in this mode is based on the operating conditions encountered by naval
broadcasts.
The technology utilizes binary phase shift keying (BPSK) of a single tone 1800 Hz sub-carrier with a con-
stant modulation speed of 2400 Bd. Through the use of BPSK modulation and a FEC coding rate of 1/4,
the effective user data rate is 300 bps.
Baud Rate User data rate (bps) Bits per symbol (M-PSK) FEC coding rate Interleaver
2400 300 1 (BPSK) 1 / 4 long
The user data is transmitted using a continuous frame structure with 213.33 ms per frame. Each frame
starts with a preamble containing 80 symbols. The following 176 symbols are divided into four 32-symbol
data segments and three 16-symbol channel probe segments.
The 176-symbol data-probe segment immediately follows the next frame, beginning with the same 80-
symbol preamble. This repeated frame structure enables synchronization of the demodulator at any time
of transmission.
At the end of transmission, an EOM bit pattern (0x4B65A5B2, MSB first) is sent to mark the end of mes-
sage. The EOM sequence is followed by flush bits, to flush the FEC coder and to complete the transmission
of the remainder of the interleaver data block.
16 16 16 32 32 32 32 80 80
Block 1 Block 2 Block 3 Block 4
T = 213.33 ms
80
16
32
Preamble symbols
Data symbols
Channel probe symbols
Preamble