Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 98)

3-66 W A N s u i t e 5 1 6 0 / 5 1 3 0
The Static Route Table is always associated with a circuit. Access this screen by
selecting the Static Route Table from the RIP Parameters Table on the IP
Gateway Details screen.
Figure 3.53 Static Route Table Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Route Status Indicates whether a route is enabled or disabled.
The Static Routes Table screen provides the following user-activated buttons:
Route Details Screen
Access this menu by clicking on the appropriate number under the “Index”
column on the Static Route Table screen.
Button Function
Dynamic Route Table Displays all known routes.
Add New Adds a new static route.