Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 240)

5-22 W A N s u i t e 5 1 6 0 / 5 1 3 0
NOTICE: When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
“Disable.”
Utilities Menu
The UTILITIES menu is used to display and change some system operational
configurations.
Figure 5.19 Utilities Menu Tree
Maintenance Reset
This screen allows the user to reset the unit to its factory default TDM or
Packet configuration for all unit parameter values. Use the “Save” option to
write the current configuration to the unit’s non-volatile memory. The “No”
option is displayed as a null state only before the user selects and scrolls
through Maintenance Reset options
−
it serves as protection from accidentally
resetting the unit.
Values: No, TDM, Save, Packet, Packet 2, Packet 3, Packet 4
Default:No
Set Password
The Set Password screen lets you establish or change an access password for
entry to and control of the front panel interface. The password will consist of
selection of up to eight alphanumeric characters. After selecting and exiting
password entry, the front panel will require this same selection of coded
values to be entered prior to the display moving beyond the “idle” screen.
Select the Set Password option to open the ENTER PASSWORD screen; a
blinking cursor appears over the first character or digit to be entered or
modified. To establish a unit password, press the
SCROLL button to increment
the characters and digits (0– 9, A– Z, a– z). Pressing the SELECT button
accepts the value and moves the cursor to the right. After entering all the
characters that define your password, press the
SELECT button; the menu will
then prompt you to “Verify” the password. Reenter the password exactly as
before and again press
SELECT . A correctly entered password advances the
Maint Rst
Utilities
Set
Password
No
Save
TDM
Pkt
Pkt 2
Pkt 3
Pkt 4
Enter Password
LCD E/D Save and Restart
Status
Not Needed
Required
Recommended