Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 233)

F r o n t P a n e l L C D I n t e r f a c e 5-15
Network 1, Network 2, Network – Timing is derived from the Network port
recovered clock.
Serial 1, Serial 2, Serial – Timing is derived from the Serial port recovered
clock.
Zero Suppression Determines whether ones density insertion is activated after 15 zeros. This
parameter is ignored if the Coding parameter is set to “B8ZS”.
Values: Disable, Enable
Default:Disable
PRM Lets you establish which performance messaging standard will be employed
to initiate Performance Report Message (PRM) functions. Setting this field to
“Enable” instructs the unit to use ANSI T1.403, which sends a PRM once
every second. Setting this field to “Disable” instructs the unit to use AT&T
TR54016, which provides performance reporting on request only.
Values: Disable, Enable
Default:Disable
Learn DS0 Boot Determines if the unit will attempt to discover active DS0s (after power-up,
Save and Restart). Active DS0s will then be assigned to the first associated
network service.
Values: Disable, Enable
Default: Disable
Learned DS0 As Specifies the rate at which each discovered DS0 will be set.
Values: As 56K/64K
Default: As 64K
Learn DS0 Now Learns which DS0s are active and assigns them to the first associated network
service. Learned DS0s are based on the idle pattern specified in the Channel
Table.
Network 2 Configuration Menu (5160 Only)
The NET 2 CONFIG menu is used to set up parameter values for the port
labeled as “NET #2” on the WANsuite 5160.