Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 51)

W e b S e r v e r I n t e r f a c e 3-19
NOTICE: Diagnostic Messages must be set to “Enable” for the Verilink
Configuration Wizard to work.
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
DTR Alarm Control and Status Table
In addition to the configurable fields, the Supervisory screen displays a table
that lets you set the Data Terminal Ready (DTR) Alarm Control parameters
and view the current DTR Alarm Status.
Choices for DTR Alarm Control are “Enable” and “Disable”; the default
setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit
to go into alarm on a loss of DTR, which occurs when the Serial port detects
that the DTR signal is low. The DTR Status field indicates the current state of
the DTR alarm.
Services Screen
The Services screen (Figure 3.15) displays the unit’s defined services and the
Interface, Type, Pair, and Status parameters for each service.
Figure 3.15 Services Screen
The Status for a particular service will display as one of the following: