Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 179)

V T 1 0 0 I n t e r f a c e 4-51
Filter By IP Address Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
Enter IP Port or Select
From List
Establishes the IP port by which the rule will filter IP traffic (if enabled).
Filter By IP Port Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.
Tx Alarm Threshold Specifies the threshold in bits per second for the Transmit Alarm on this rule.
Tx Alarm Shows the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen (Figure 4.44), which can be accessed from
the bottom of the Rule Config screen, displays the number of frames and
octets sent over a DLCI that have been counted in accordance with the
Service Aware “rule” that has been established for a Service. As such, it is
frame relay specific (i.e., DLCIs only occur in frame relay links). In addition,
this screen provides data rate performance information for the period of time
you have specified in the Period field (see below).
Figure 4.44 Traffic Meter Statistics Screen
The Traffic Meter Statistics screen reports on the following parameters:
• Tx Frames
• Tx Octets
• Rx Frames
• Rx Octets
• Rate Peak – the peak data rate for the viewed period (see below)
• Rate Average – the average data rate for the viewed period (see below)