Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 33)

W e b S e r v e r I n t e r f a c e 3-1
C H A P T E R
3
C HAPTER 3
W
EB
S
ERVER
I
NTERFACE
The WANsuite 5160/5130 has an innovative, embedded Web-based user
interface (WANsight) for remote configuration and real-time reporting via
Microsoft Internet Explorer 5.0 or higher. Access to the Web server interface
and how the interface is used to configure the WANsuite 5160/5130 unit are
described in detail below.
NOTICE: Verilink recommends the use of Microsoft’s Internet Explorer 5.0 or
higher because if you use other Internet browsers to access the Web
server interface, some screen elements will not display as described in
this manual.
NOTICE: The material presented in this chapter follows the order listed in the
navigation bar on the left side of the Web Server interface screen.
However, because the parameters you specify in the Service Table
attach protocols to interfaces, you must configure the Service Table
first. (See Services Screen on page 3-19.) You will not be able to
allocate channels (see Channel Table Details Screen on page 3-26)
until the Service Table has been configured.
Configuration through the VT100 interface is covered in Chapter 4, and
configuration through the front panel is covered in Chapter 5.
Web Server Access
You can access the Web Server interface by connecting to its IP address. This
connection can be directly through the 10/100 Ethernet port, in-band via PPP
over any port, or in-band via encapsulated IP traffic on the Frame Relay
circuit.
NOTICE: Any changes to the unit’s configuration MUST be followed by a
“Submit” if there is a “Submit” button on the menu. If you
change the Service Table, you must perform a “Save and
Restart.”